Hook up wood stove to furnace

Added: Timothey Kincannon - Date: 25.07.2021 09:54 - Views: 36466 - Clicks: 7066

Forums New posts Search forums Terms and Rules. What's new New posts New media New media comments Latest activity. Media New media New comments Search media. Log in Register. Search titles only. New posts. Search forums. Terms and Rules. Log in. Install the app.

You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser. Linking indoor woodstove furnace to existing gas furnace ductwork. Thread starter winsormcbeth Start date Jan 24, Jan 24, I bought an Englander model wood furnace and have it in my unfinished, uninsulated basement.

My existing propane fueled Furnace is on one end of the basement and the wood furnace is at the other end so they are at least feet apart. It is my understanding that you want the hot air outlet ductwork from the wood furnace to connect to the main central furnace right above the actual furnace, right? Is the fan that comes with the Englander cfm going to be powerful enough to push air through 60 ft of duct work to get to my main furnace ductwork and then let my main furnace fan do the rest of Hook up wood stove to furnace work? Just looking for some advice.

Jan 25, No flex duct allowed unless solid metal. You need 2" clearance of duct work hot line for the first 10 ft and 1" there after to combustibles for code compliance. The fact that you have some 60 ft before getting to your other furnace is actually a blessing, if you have an AC coil on the propane rig. Those coils won't withstand the high heat of a wood furnace so normally it would have to have a bypass damper installed or just one to prevent high heat back flow to that area.

It is very important to tie the cold air return to the wood furnace also so you get a full loop, otherwise it just will not work correctly.

Note : conventional duct work does not have the code clearances for solid fuel appliances now days. This would apply to most homes constructed since the 50's. Conventional furnaces have a high limit cutoff and a low limit on, this is why they cycle and won't overheat ductwork or themselves. Your wood unit does not. ed Mar 9, Messages 91 Location southern maryland. I have that same furnace I used 8" black stove pipe for the first 5' coming off the furnace then regular duct work with a one way butterfly damper in it to my homes furnace. Do not run your house furnace blower this will fight the Englander's blower and could over heat the furnace, you do not need to do anything with your return side of your duct work, the englander will pull air from the room its in.

Been running it this way for 3 years with no problem this way is also per Englander's installation specs. My run of duct work is approx. So at a 60' ft run you will loose a little umph but I think you should be ok. The damper and other supplies including installation guide for your stove can be found at Englanders website. You must log in or register to reply here.

Hook up wood stove to furnace

email: [email protected] - phone:(239) 601-7994 x 5087

How to Connect Your Wood Stove Fan to Central Heating Ducts